Page 1 of 1
hey how do i set the path in a bat file and config file
Posted: 03 Aug 2011 10:54
by flyhigh427
hey yall
how do i set the path to find the path, to itself?
i mean if it s in drive a this time then in drive f the next time etc.
is there a way?
thanks
Code: Select all
@ECHO OFF
path=a:\;a:\oak
a:\smartdrv.exe
prompt=$p$g
LH MSCDEX.exe /d:USBCD001
Code: Select all
DEVICE=a:\HIMEM.SYS /TESTMEM:OFF
DEVICE=a:\EMM386.EXE NOEMS
DOS=HIGH,UMB
device=a:\oak\oakcdrom.sys /D:mscd001
;device=a:\oak\btdosm.sys
;device=a:\oak\flashpt.sys
;device=a:\oak\btcdrom.sys /D:mscd001
;device=a:\oak\aspi2dos.sys
;device=a:\oak\aspi8dos.sys
;device=a:\oak\aspi4dos.sys
;device=a:\oak\aspi8u2.sys
;device=a:\oak\aspicd.sys /D:mscd001
shell=a:\command.com /E:1024 /P
FILES=30
BUFFERS=20
lastdrive=z
Re: hey how do i set the path in a bat file and config file
Posted: 03 Aug 2011 11:07
by Ed Dyreen
'
You mean how to get the active drive ?
Code: Select all
rem :: Get Boot Drive
rem ::
rem ::OUTPUT:
rem :: @Drive.Boot BYVAL Return; Where @Drive.Boot = '[A-Z]:'
rem ::
rem ::(
>"%Drive.RAM%\DRVStBt.BAT" "%Drive.RAM%\DRVGTACT.EXE"
rem ::
call "%Drive.RAM%\DRVStBt.BAT"
rem ::
set Drive.Boot=%drive%
set drive=
rem ::)
This program will not run from config.sys though, but you should avoid loading devices from config.sys anyways.
Code: Select all
DOS=HIGH,UMB
Files=40
Buffers=30
Stacks=0,0
set Drive.RAM=X:
set Drive.CD=T:
set Drive.Server=Y:
install=SHSURDRV.EXE 8192k,D480,X: /Q
install=TUNZ.COM -o BOOT.ZIP X:\
SHELL=X:\COMMAND.COM /E:4096 /P
example: load device driver from autoexec
Code: Select all
"%Drive.RAM%\SHOWMENU.EXE" Analizing UDMA settings
rem ::(
If not ["%UDMA%"] == ["1"] goto AUDMASD ()
echo.Loading UltraDMA hard-disk driver
rem ::(
"%Drive.RAM%\DEVLOAD.COM" UDMA.SYS
rem ::)
:AUDMASD ()
rem ::)
http://netbootdisk.comBy the way, there are much better ways for getting access to high and upper memory more efficiently than the outdated emms and himem.
http://www.mdgx.com
Re: hey how do i set the path in a bat file and config file
Posted: 03 Aug 2011 11:13
by flyhigh427
thanks it helped alot